We use these on all of our 1000HP+ builds. These are LS3 height (38mm) and have an EV6/14 USCAR electrical connector.
***NOTE*** After using these injectors and have come to remove them from the vehicle or Intake Manifold, please submerge them in ATF or WD40. Make sure they are fully submerged; Clean thoroughly with brake cleaner when attempting re-install. Failure to isolate injectors with ATF/Lubricant will cause seizure of the pintle, especially if you live in a humid climate.
These injectors flow 210lbs or 2200cc at 43.5 psi base pressure.
Injector specs:
Hi-Resistance: 9.1 Ohms / Hi-Impedance
Dead Time: 0.45ms at 14 volts
Static Flow Rate @ 43.5 PSI ( 300kPa ) w/Gas: 2200 cc/min = 210 lb/hr
Static Flow Rate @ 58 PSI ( 400kPa ) w/Gas: 2550 cc/min = 240 lb/hr
Static Flow Rate @ 78.5 PSI ( 500kPa ) w/Gas: 2865 cc/min = 273 lb/hr
Static Flow Rate @ 88 PSI ( 600kPa ) w/Gas: 3155 cc/min = 300 lb/hr
Static Flow Rate @ 101.5PSI ( 700kPa ) w/Gas: 3350 cc/min = 320 lb/hr
Connector: EV14 Injector Length: O-Ring to O-Ring: 1.5. / 37.5 mm
Injector Body Diameter: 16mm
O-Ring: 14.5mm VitonThese injectors are NOT compatible with gas/petrol with MTBE Oxygenate
Genuine authentic Bosch injector. SET OF 8.
Bosch 210 lb Injectors
There is no warranty on these injectors.
